Dowload the full specification sheet here:

Specifications:

Sealing: None

Voltage: 220-240 Vac 50/60Hz

Markings: CE

Colour: Cool White 5-6000K

Power: 12 Watts

Output: 850 lm average

Efficacy: 70lm/W

LEDs: 150

Micatron Lighting Innovations Ltd supply and manufacture a range of products which are certified to comply with International standards.

Time lapse motion capture - Thursday 12 June 2008 - 9.45pm to 10.15pm

See high resolution version here.

Products

LED Lighting Solutions

Innovation bring this new LED DD with significant saving on both electricity and maintenance cost

Product Code: MICA2D12W

The Micatron"Plug & Play" LED replacements for 2D lamps are perfect for commercial applications where high efficiency and long life, to reduce maintenance costs, are important. They emit no UV, run cool and have a service life up to 50000 hours and have a 5 year warranty against premature failure. Unlike fluorescent lamps they are not affected by cold temperatures. Due to the high number of LEDs used, they provide an attractive even glow compared with a traditional 2D where the unsightly element can often be seen.

These 2D replacements dimensions are equivalent to a traditional 28 Watt 2D

They simply plug into the existing luminaire socket without the need for rewiring.

PIR operation: LED products, unlike fluorescent lamps, are not prone to premature failure when used with a PIR. Stresses on a normal lamp at turn on causes early failure in more than 25% of cases. LEDs do not have this problem since they are a semiconductor and are unaffected. Additionally, due to their ability to turn on at full brightness even in cold conditions, they are particularly suitable for PIR operation in unheated areas which improves safety.

For emergency operation we provide an integral non-maintained 1W or 3W white LED with full 3 hour battery operation.

Product Benefits:

• Replace the application of a Fluorescent 2D lamp of 28W
• Long Lamp Life
• Beam angle of 105 degrees
• About 60% energy savings
• No UV or near infrared radiation
• Instant full output, no delay
• Efficient generation of white light
• Peak intensity (candela) and beam angle match Fluorescent equivalents

Options:

Colour: Warm White 3-4000K

Emergency: 1W or 3W white, 3hr operation, non-maintained

Please call to discuss Emergency and PIR operation

Our LED 2D replacement lamps are simple to install. Disconnect the supply.

Switch Start - simply remove the starter and install the LED replacement into the socket.

With electronic ballasts, YOU MUST disconnect the wires from the ballast and rejoin. ie disconnect the ballast from the circuit. Install the LED replacement into the socket. Reconnect the supply and the lamp will operate normally.

Please call our Technical Department for any advice required on 01179 511002
NOTE : Only use a qualified electrician to remove the ballast.